PageRenderTime 6ms CodeModel.GetById 2ms app.highlight 1ms RepoModel.GetById 1ms app.codeStats 0ms

/Documentation/sound/oss/Soundblaster

https://bitbucket.org/evzijst/gittest
#! | 53 lines | 39 code | 14 blank | 0 comment | 0 complexity | b8ca28b0efa9aff14e8a6d1166d8e7bf MD5 | raw file
 1modprobe sound
 2insmod uart401
 3insmod sb ...
 4
 5This loads the driver for the Sound Blaster and assorted clones. Cards that
 6are covered by other drivers should not be using this driver.
 7
 8The Sound Blaster module takes the following arguments
 9
10io		I/O address of the Sound Blaster chip (0x220,0x240,0x260,0x280)
11irq		IRQ of the Sound Blaster chip (5,7,9,10)
12dma		8-bit DMA channel for the Sound Blaster (0,1,3)
13dma16		16-bit DMA channel for SB16 and equivalent cards (5,6,7)
14mpu_io		I/O for MPU chip if present (0x300,0x330)
15
16sm_games=1	Set if you have a Logitech soundman games
17acer=1		Set this to detect cards in some ACER notebooks
18mwave_bug=1	Set if you are trying to use this driver with mwave (see on)
19type		Use this to specify a specific card type
20
21The following arguments are taken if ISAPnP support is compiled in
22
23isapnp=0	Set this to disable ISAPnP detection (use io=0xXXX etc. above)
24multiple=0	Set to disable detection of multiple Soundblaster cards.
25		Consider it a bug if this option is needed, and send in a
26		report.
27pnplegacy=1	Set this to be able to use a PnP card(s) along with a single
28		non-PnP (legacy) card.  Above options for io, irq, etc. are
29		needed, and will apply only to the legacy card.
30reverse=1	Reverses the order of the search in the PnP table.
31uart401=1	Set to enable detection of mpu devices on some clones.
32isapnpjump=n	Jumps to slot n in the driver's PnP table. Use the source,
33		Luke.
34
35You may well want to load the opl3 driver for synth music on most SB and
36clone SB devices
37
38insmod opl3 io=0x388
39
40Using Mwave
41
42To make this driver work with Mwave you must set mwave_bug. You also need
43to warm boot from DOS/Windows with the required firmware loaded under this
44OS. IBM are being difficult about documenting how to load this firmware.
45
46Avance Logic ALS007
47
48This card is supported; see the separate file ALS007 for full details.
49
50Avance Logic ALS100
51
52This card is supported; setup should be as for a standard Sound Blaster 16.
53The driver will identify the audio device as a "Sound Blaster 16 (ALS-100)".