/boards/stm32VLDiscovery/hw/hw_led.h
C Header | 71 lines | 26 code | 9 blank | 36 comment | 2 complexity | 12972c6299649b7809c5fb2c07f8cad9 MD5 | raw file
Possible License(s): GPL-2.0, BSD-3-Clause
- /**
- * \file
- * <!--
- * This file is part of BeRTOS.
- *
- * Bertos is free software; you can redistribute it and/or modify
- * it under the terms of the GNU General Public License as published by
- * the Free Software Foundation; either version 2 of the License, or
- * (at your option) any later version.
- *
- * This program is distributed in the hope that it will be useful,
- * but WITHOUT ANY WARRANTY; without even the implied warranty of
- * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
- * GNU General Public License for more details.
- *
- * You should have received a copy of the GNU General Public License
- * along with this program; if not, write to the Free Software
- * Foundation, Inc., 51 Franklin St, Fifth Floor, Boston, MA 02110-1301 USA
- *
- * As a special exception, you may use this file as part of a free software
- * library without restriction. Specifically, if other files instantiate
- * templates or use macros or inline functions from this file, or you compile
- * this file and link it with other files to produce an executable, this
- * file does not by itself cause the resulting executable to be covered by
- * the GNU General Public License. This exception does not however
- * invalidate any other reasons why the executable file might be covered by
- * the GNU General Public License.
- *
- * Copyright 2010 Develer S.r.l. (http://www.develer.com/)
- * All Rights Reserved.
- * -->
- *
- * \brief Led on/off macros for STM32-P103 board.
- *
- * \author Andrea Righi <arighi@develer.com>
- */
- #ifndef HW_LED_H
- #define HW_LED_H
- #include <cfg/macros.h>
- #include <io/stm32.h>
- #include <drv/gpio_stm32.h>
- #include <drv/clock_stm32.h>
- #define LED_PIN BV(8)
- #define LED_GPIO_BASE ((struct stm32_gpio *)GPIOC_BASE)
- #define LED_ON() \
- do { \
- stm32_gpioPinWrite(LED_GPIO_BASE, LED_PIN, 1); \
- } while (0)
- #define LED_OFF() \
- do { \
- stm32_gpioPinWrite(LED_GPIO_BASE, LED_PIN, 0); \
- } while (0)
- #define LED_INIT() \
- do { \
- /* Enable clocking on GPIOA and GPIOC */ \
- RCC->APB2ENR |= RCC_APB2_GPIOC; \
- /* Configure the LED pin as GPIO */ \
- stm32_gpioPinConfig(LED_GPIO_BASE, \
- LED_PIN, GPIO_MODE_OUT_PP, \
- GPIO_SPEED_50MHZ); \
- } while(0)
- #endif /* HW_LED_H */